1.01.0210.11220 - CAN-CR110/FO - Ixxat Vietnam

Giá bán: Liên hệ

Mã sản phẩm: 1.01.0210.11220

Thương hiệu: HMS

Tình trạng: Còn hàng

Order number:

1.01.0210.11020 - CAN-CR110/FO, with bus termination resistor

1.01.0210.11220 - CAN-CR110/FO, without bus termination resistors

Tư vấnhotline0965 746 247

CAN-CR110/FO

CAN / CAN FD repeater with screw terminals
and fiber optic connector

The CAN-CR110/FO is used for galvanic isolation of two segments of a CAN / CAN FD network. As a special feature, the repeater separates a defective segment from the rest of the network, allowing the remaining network to continue working. After the fault has been eliminated, the segment is automatically switched back to the network. The galvanic isolation is provided for the CAN / CAN FD segments as well as for the power supply.

FEATURES AND BENEFITS

  • Fiber optic enables transmission in areas with high electromagnetic disturbances
  • CAN and CAN FD interfaces in one device
  • Cost savings due to simple wiring
  • Increased system reliability
  • Almost no influence on real-time behavior

CONTENTS OF DELIVERY

  • CAN-CR110/FO
  • User manual

TECHNICAL SPECIFICATIONS

Display Transmit and defective segment (two duo LEDs, one for
each segment), Power (one LED)
CAN bus interface ISO 11898-2 with CAN choke. Two screw terminals.
CAN variant available with and without integrated CAN termination.
CAN baudrate Up to 1 Mbit/s
CAN FD bus interface ISO CAN FD and nonISO CAN FD
CAN FD baudrate 500 kbit/s (arbitration bitrate) and up to 4 Mbit/s  (flexible data rate)
Delay typ. 300 ns (corresponds to ~60 m bus length) between the wire
connection of a FO Repeater through the fiber optic cable to the wire
connection of a second FO Repeater (not including the signal delay
time of the fiber optics, which is ~5 ns/m)
FO transmitter Broadcom HFBR 1404Z, 820 nm
FO receiver Broadcom HFBR 2402Z, 820 nm
FO line  F-SMA connector; Multi-mode fiber optic line (only glass); recommended:
50/125 µm, 62,5/125 µm, also compatible with: 100/140 µm,
200 µm (pay attention to max. line length)
Max. line length between
two FO repeaters
50/125 µm: 1500 m, 62,5/125 µm: 2000 m
Power supply 9-36 V DC, typ. 70 mA, max. 100 mA, through terminals
Galvanic isolation 1 kV DC / 1 sec, 500 V AC / 1 min; CAN 1, CAN 2 and
power supply are galvanically isolated from each other.
Certification CE, FCC
Temperature range  -20 ºC ... +70 ºC
Housing, size Plastic enclosure, 22.5 x 105 x 120 mm

 

Order number

1.01.0210.11020 CAN-CR110/FO, with bus termination resistor
1.01.0210.11220 CAN-CR110/FO, without bus termination resistor

Để được tư vấn miễn phí

Quý khách hàng vui lòng để lại thông tin bên dưới

zalo