Converter from ISO 11898
to fiber optic cable
This product is not recommended for new developments. For new developments we recommend to use a successor product of the IXXAT CAN-CR2xx series.
The FO Repeater is used for the conversion of the CAN-signal from copper wire (ISO 11898-2) to fiber optic cables. This provides a complete isolation and protection against EM-influences.
One special feature of the Repeater is that it separates a defective segment from the rest of the network so that the remaining network can continue working. After elimination of the defect, the segment is switched into the network again.
|Display||Sending (2 green LEDs), defective segment (2 red LEDs)|
|CAN bus interface||ISO 11898-2. Screw terminals. CAN termination resistors are integrated (switchable).|
|FOC connection||2 x ST terminals for duplex line (Glass 50/125 µm duplex)|
|Baudrate||Up to 1 Mbit/s|
|Delay||~300 ns (translates into ~60 m (~90 ft.) bus length) between the wire connection of a FO Repeater through the fiber optic cable to the wire connection of a second FO Repeater (not including the signal delay time of the fiber optics, which is ~5 ns/m)|
|Power supply||9-35 V DC, 3 W typ., through terminals|
|Galvanic isolation||1 kV, 1 sec.; CAN 1|
|Temperature range||-20 ºC ... +60 ºC|
|Housing, size||Plastic enclosure, 110 x 75 x 22 mm (without FO connector)|
|1.01.0063.01020||CAN Fiber Optic Repeater - Glass fiber version with ST connector|